Fall Maintenance

• Start-Up
• Test Air flow System (for dangerous carbon monoxide)
• Test Gas Valve Operation and for Gas Leaks
• Motor Amperage Inspection
• Blower Motor Inspection
• Clean Furnace or Boiler
• Control Compartment Cleaning
• Fan Belt Inspection & Adjust as Needed
• Filter Replacement or Cleaning
• Clean, Check, & Adjust Pilots
• Clean, Check, & Adjust Burners
• Inspect Blower Fan Blade Wear & Balance
• General Wear, Rust, & Deterioration Inspection
• Inspect Thermocouple
• Safety Controls Inspection
• Starter Contacts, Switches & Relay Inspection
• Starting Components Inspection
• Temperature Differential Inspection
• Inspect Heat Exchanger for Leaks
• Thermostat Calibration Inspection
• Check Humidifier & Hot Water Tank (if applicable)
• Oil Motor & Blower (if necessary)
• Check Heating Temperature at Supply Register
• Complete Cycle Operation Check 

Coming Soon!